Siemens SCALANCE W760 - No Ip Echo-Reply

Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
266 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call the command without parameters:
ip echo-reply
Result
"ICMP echo reply messages" are enabled.
Further notes
You disable the setting with the no ip echo-reply command.
You can display the setting of this function and other information with the
show ip
information
command.
7.1.2.4
no ip echo-reply
Description
With this command, you disable the "ICMP echo reply messages".
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip echo-reply
Result
"ICMP echo reply messages" are disabled.
Further notes
You change the setting with the ip echo-reply command.
You can display the setting of this function and other information with the
show ip
information
command.