Siemens SCALANCE W760 - No Nat Timeout (Client)

Layer 3 functions
9.1 NAT
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
358 Configuration Manual, 11/2014, C79000-G8976-C351-03
9.1.3.7
no nat timeout (client)
Description
With this command, you delete the time period for the TCP / UDP connection.
Note
This command is only available in the client mode
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
no nat {tcp|udp} timeout
The parameters have the following meaning:
Parameters
Description
Values
tcp
TCP connection
-
udp
UDP connection
-
Result
The time period for the TCP / UDP connection was set to the default setting.
Further notes
You show the NAT configuration and the translation list with the show nat command.
You configure the time with the
nat timeout command.
See also
show nat (client) (Page 349)