Siemens SCALANCE W760 - Wlan Security Ap-Radius-Authenticator Primary

Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
368 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator port-number <index (1-2)> <1-65535>
The parameters have the following meaning:
Parameters
Description
Values or range of values
index
Index of the RADIUS server
1...2
1-65535
Number of port
1...6553
Result
The input port is configured.
Further notes
You display the setting with the show wlan security ap-radius-authenticator command.
See also
show wlan security ap-radius-authenticator (Access Point) (Page 361)
10.2.4.6
wlan security ap-radius-authenticator primary
Description
With this command, you configure the RADIUS server as primary server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode and the "wlan security ap-radius-authenticator
address" is configured.
The command prompt is as follows:
cli (config-wlan)#