Siemens SCALANCE W760 - No Wlan Dfs; Wlan Dtim (Access Point)

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
169
6.1.5.31
no wlan dfs
Description
With this command, you disable the "DFS" function. This setting is activated as default.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan dfs
Result
The DFS function is enabled.
Further notes
You display the setting with the show wlan basic <wlan 0/X> command.
You enable the function with the
wlan dfs command.
See also
wlan dfs (Page 168)
6.1.5.32
wlan dtim (access point)
Description
With this command, you configure the DTIM interval. The DTIM interval (1-15) specifies the
number of beacons to be sent before the access point sends the packets
(broadcast/unicast/multicast) to the client.
If, for example, you enter "5", this would mean that the access point collects the packets and
sends them after every fifth beacon.
Note
This command is available only in access point mode.