Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
361
show wlan security
Description
This command shows the security settings of the device, for example the encryption method.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show wlan security <wlan 0/X | vapX 0/Y>
The parameters have the following meaning:
Values or range of values
WLAN interface
Only available in client mode
Enter a valid interface.
VAP interface
Only available in Access Point mode
Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
The settings are displayed.
show wlan security ap-radius-authenticator (Access Point)
Description
This command shows the settings of the RADIUS server.
Note
This command is available only in access point mode.
To Next Page
Loading...
Need help?
General
