Siemens SCALANCE W760 Configuration Manual

Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
68 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call up the command with the following parameters:
delete{showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
showfiles
Shows the available files
-
filetype
Keyword for the file type to be deleted
-
filetype
Name of the file type
max. 100 characters
Result
The files are displayed or the file is deleted.
3.2.4.2
tftp filename
Description
With this command, you assign a name to a file type.
The file type decides the type that is affected by the
tftp load or tftp save action. The
name decides the file to be copied to or from the TFTP server.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp filename {showfiles|filetype< filetype >name<filename>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
showfiles
Shows the available files -
filetype
Keyword for a file type to be assigned
a name
-
filetype
Name of the file type
max. 100 characters
name
Keyword for a file name to be assigned
to the file type
-
filename
Name of the file
max. 100 characters

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English