Siemens SCALANCE W760 Configuration Manual

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
143
Result
The function is enabled.
Further notes
You display the setting with the show wlan allowed channels <wlan 0/X>command.
You disable the function with the
no wlan allowed channels only command.
See also
wlan allowed channels (Page 141)
no wlan allowed channels only (Page 143)
6.1.5.3
no wlan allowed channels only
Description
With this command, you disable the "Use allowed channels only" function. This is the default
setting.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan allowed channels only
Result
The function is disabled.
Further notes
You display the setting with the show wlan allowed channels <wlan 0/X> command.
You enable the function with the
wlan allowed channels only command.
See also
wlan allowed channels only (Page 142)

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English