Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
413
The entry has been made in the logbook.
client config
Description
With this command, you enable one of the clients that processes or forwards the messages
of the device.
The following clients are available:
●
syslog: sends the messages to the Syslog server
●
trap: sends the messages as SNMP trap to a configured recipient
●
email: sends the messages as e-mail
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
client config {syslog|trap|email|all}
The parameters have the following meaning:
Enables the client that sends the messages to the Syslog server
Enables the client that sends the SNMP traps
Enables the client that sends the e-mails
Enables all clients at once
The function of the client selected for the transfer is enabled.
You display the status of the events and the clients with the show events config command.
You disable a client with the
no client config command.
To Next Page
Loading...
Need help?
General
