Siemens SCALANCE W760 - Time Settings for the Spanning Tree Protocol

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
239
Syntax
Call up the command with the following parameters:
no spanning-tree[mst <instance-id(1-64)>]priority
The parameters have the following meaning:
Parameter
Description
Range of values / note
mst
Keyword for a Multiple Spanning Tree
instance
-
instance-id
Number of the instance 1 ... 64
Result
The priority of the device is reset to the default value.
Further notes
You configure the setting with the spanning-tree priority command.
You display this setting and other information with the commands that start with
show
spanning tree ...
.
6.3.3.16
Time settings for the Spanning Tree protocol
spanning-tree
Description
With this command, you configure the various time settings of the spanning tree function:
● With the
forward-time option, you configure the time after which a port changes its
spanning tree status from "Blocking" to "Forwarding".
● With the
hello-time option, you configure the time after which the bridge sends its
configuration BPDUs.
● With the
max-age option, you configure the time after which the information of the BPDUs
becomes invalid.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#