Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
141
wlan allowed channels
Description
This command specifies which of the permitted channels the device can use. A list of the
permitted channels is created.
● The "Allowed channels only" function is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan allowed channels{ all | none | {[add][del]} [ 2.4 | 4 | 5 ] <channels> }
The parameters have the following meaning:
All permitted channels are entered in the list.
• Access point:
All channels except for the following channels are deleted:
– Operative channel
– Alternative DFS channel
If "Auto" is set for the channel, the list is deleted and the first valid
channel of the selected frequency band is applied.
• Client:
The list is deleted and the first valid channel of the selected frequency
band is applied.
The channels located in the <channel> parameter are added to the list.
The channels located in the <channel> parameter are deleted from the
list.
Optional parameter. Use this parameter to specify the frequency band
from which you want to add one or more channels to the list.
Optional parameter. Use this parameter to specify the frequency band
from which you want to add one or more channels to the list.
To Next Page
Loading...
Need help?
General
