Siemens SCALANCE W760 - No Smtp-Server

Network protocols
7.5 SMTP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
333
7.5.4.2
no smtp-server
Description
With this command, you delete an SMTP server entry.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no smtp-server { ipv4 <ucast_addr> | fqdn-name <FQDN(100)> }
The parameter has the following meaning:
Parameter
Description
Range of values
ipv4
Keyword for an IPv4 address
-
ucast_addr
Value for an IPv4 address Enter a valid IPv4 address.
fqdn-name
Keyword for a domain name.
-
FQDN(100)
Domain name (Fully Qualified
Domain Name)
Maximum of 100 characters
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The SMTP server entry is deleted.
Further notes
You configure an e-mail server entry with the smtp-server command.