Siemens SCALANCE W760 Configuration Manual

Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
51
Result
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder
$$$ is replaced by the following name of the interface:
Type of interface
Command prompt
wlan
cli(config-if-wlan-0-$)#
wds
cli(config-if-wds$-0-$)#
vap
cli(config-if-vap$-0-$)#
vlan
cli(config-if-vlan-$)#
fast-ethernet
cli(config-if-F-0-$)#
The placeholders $ or $-$ denote the numbering of the interface.
For the value ranges for the VLAN logical interface, refer to the upper table. You can only
call up interfaces that you created with the
vlan command.
The ranges of values from the physical interfaces depend on the hardware configuration.
Further notes
You exit the Interface Configuration mode with the end or exit command.
You delete a logical interface with the
no interface command.
You display the status and the configuration of the interfaces with the
show interfaces
command.
3.1.9.5
no interface
Description
With this command, you delete a logical interface.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English