Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
298 Configuration Manual, 11/2014, C79000-G8976-C351-03
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
With this command, you specify the interface via which the IPv4 addresses are dynamically
assigned.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call up the command with the following parameters:
set-interface {vlan <vlan-id (1-4094)> | <interface-type> <interface-id> }
The parameters have the following meaning:
Keyword for a VLAN connection.
Number of the
1 ... 4094
Type or speed of the interface
Enter a valid interface
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
The interface is assigned. Before the IPv4 address band can be used, it still needs to be
activated.
You display the setting with the show ip dhcp-server pools command.
You enable the IPv4 address band with the
pool-enable command.
To Next Page
Loading...
Need help?
General
