Security and authentication
10.3 Management Access Control List
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
400 Configuration Manual, 11/2014, C79000-G8976-C351-03
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
authorized-manager ip-source
Description
With this command, you configure the interfaces and protocols via which an authorized
manager is allowed to access the device.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
authorized-manager ip-source <ip-address>
[{<subnet-mask>|/<prefix-length(1-32)>}]
[interface[<interface-type<0/a-b,0/c,...>]
[<interface-type<0/a-b,0/c,...>]]
[vlan<a,b or a-b or a,b,c-d>] [service[snmp][telnet][http][https][ssh]]
The parameters have the following meaning:
Specifies the network or the IP address for
which the IP manager is authorized
Enter a valid IPv4 address or a
Subnet mask that restricts the authorization
Decimal representation of the mask as a number
of "1" bits
1 .. 32
Keyword for a an interface description -
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
Keyword for a VLAN connection
To Next Page
Loading...
Need help?
General
