Siemens SCALANCE W760 - No Alias; Duplex

Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
58 Configuration Manual, 11/2014, C79000-G8976-C351-03
3.1.10.2
no alias
Description
With this command, you delete the name of the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no alias
Result
The name of the interface is removed.
Further notes
You configure the name of the interface with the alias command.
3.1.10.3
duplex
Description
Certain interfaces can be operated in full duplex mode or half duplex mode. The options here
depend on the connected device.
Optical connections, for example, are always operated in full duplex mode since they have a
fiber for each transmission direction.
With this command, you configure the duplex mode of an interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#