Siemens SCALANCE W760 - Show Wlan Client (Client)

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
123
6.1.1.8
show wlan client (Client)
Description
This command shows the client configuration of the device, for example how the MAC
address is assigned to the client.
Note
This command is only available in the client mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan client <wlan 0/X>
The parameter has the following meaning:
Parameter
Description
Values or range of values
wlan 0/X
WLAN interface
Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The following client settings are displayed:
● MAC Mode
● Manual MAC Address
● Any SSID
● Roaming Threshold
● Background scan mode
● Background Scan Interval
● Scan Channels