Siemens SCALANCE W760 - No Spanning-Tree

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
228 Configuration Manual, 11/2014, C79000-G8976-C351-03
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
spanning-tree
Result
The spanning tree function is enabled.
Further notes
As default the function is "enabled".
You disable the spanning tree function with the
no spanning tree command.
You can display the status of this function and other information with the
show spanning tree
detail
command.
You can display information about active ports with the
show spanning tree active
command.
6.3.3.2
no spanning-tree
Description
With this command, you disable the spanning tree function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree
Result
The spanning tree function is disabled.