Siemens SCALANCE W760 - Wlan Antenna Cable-Length

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
149
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)"
Result
The additional attenuation is specified.
Further notes
You show the set value with the show wlan antennas <wlan 0/X> command.
6.1.5.10
wlan antenna cable-length
Description
With this command, you configure the cable length between the device and the external
antenna.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna cable-length <index(1)> <meter(0-30)>
The parameters have the following meaning:
Parameter
Description
Values or range of values
index
Antenna connector
1
meter Cable length in meters [m] 0...30
Default: 0
Result
The cable length is specified.
Further notes
You show the set cable length with the show wlan antennas <wlan 0/X> command.