Functions specific to SCALANCE
4.2 Signal recorder
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
85
no web-session-timeout
Description
With this command, you disable the automatic logoff.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no web-session-timeout
Automatic logoff is disabled.
You enable automatic logoff with the web-session-timeout command.
You display the current timeout setting with the
show web-session-timeout command.
This section describes the commands relevant for working with the signal recorder.
show wlan signal-recorder (Client)
Description
This command shows the status of the signal recorder. You can call the command before,
after or during the recording.
Note
This command is only available in the client mode.
To Next Page
Loading...
Need help?
General
