Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
370 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call up the command with the following parameters:
no wlan security ap-radius-authenticator primary <index (1-2)>
The parameter has the following meaning:
Values or range of values
Index of the RADIUS server
The primary server is disabled.
You enable the setting with the wlan security ap-radius-authenticator primary command.
You display the setting with the
show wlan security ap-radius-authenticator command.
wlan security ap-radius-authenticator primary (Page 368)
show wlan security ap-radius-authenticator (Access Point) (Page 361)
wlan security ap-radius-authenticator reauth-interval
Description
With this command, you configure the lifetime of the authentication (in seconds).
Note
This command is available only in access point mode.
● Local time management is active.
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
To Next Page
Loading...
Need help?
General
