Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
252 Configuration Manual, 11/2014, C79000-G8976-C351-03
The setting for the hello time is configured.
You can reset the setting for the hello time to the default with the no spanning-tree mst
hello-time
command.
You display this setting and other information with the commands that start with
show
spanning tree ...
.
no spanning-tree mst hello-time
Description
With this command, you reset the hello time after which the bridge sends its configuration
BPDUs to the default value.
The default value is 2 seconds.
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
no spanning-tree mst hello-time
The setting for the hello time is reset to the default value.
You can configure the setting for the hello time with the spanning-tree mst hello-time
command.
You display this setting and other information with the commands that start with
show
spanning tree ...
.
To Next Page
Loading...
Need help?
General
