Siemens SCALANCE W760 - Show Wlan Overlap-Ap-List (Access Point)

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
127
Result
The following settings of the device are displayed:
● Country code
● Device mode
● Commit Mode
See also
device mode (Page 137)
commit mode (Page 138)
country (Page 139)
6.1.1.13
show wlan overlap-ap-list (access point)
Description
This command shows all access points that are visible on the set or adjacent channels (at
2.4 GHz). If entries exist here, the maximum data throughput of the access point will be
restricted.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan overlap-ap-list <wlan 0/X>
The parameter has the following meaning:
Parameter
Description
Values or range of values
wlan 0/X
WLAN interface
Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".