Siemens SCALANCE W760 - End; Exit

Description
2.6 General CLI commands
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
27
2.6.3
end
Description
With this command, you close all configuration modes.
You are then in the Privileged EXEC mode.
Requirement
You are in a configuration mode.
Syntax
Call the command without parameters:
end
Result
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
2.6.4
exit
Description
With this command, you close the current mode.
You are then at the next higher level in the user modes.
If you are in Privileged EXEC Modus or in User EXEC Modus mode, you will be logged out.
Syntax
Call the command without parameters:
exit
Result
The current mode was exited.