Siemens SCALANCE W760 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
253
6.3.5
Commands in the MSTP configuration mode
This section describes commands that you can call up in the MSTP configuration mode.
In the Global configuration mode, enter the
spanning-tree mst configuration command to
change to this mode.
● If you exit the MSTP configuration mode with the
exit command, you return to the Global
configuration mode.
● If you exit the MSTP configuration mode with the
end command, you return to the
Privileged EXEC mode.
Requirements for changing to this mode:
● MSTP is enabled
● Base bridge mode: 802.1Q VLAN Bridge
● Compatibility mode: MSTP
6.3.5.1
instance
Description
With this command, you assign a range of VLANs to an MST instance.
Requirement
You are in the MSTP configuration mode.
The command prompt is as follows:
cli(config-mst)#
Syntax
Call up the command with the following parameters:
instance <instance-id(1-64)> vlan <vlan-range>
The parameters have the following meaning:
Parameter
Description
Range of values / note
instance-id
Number of the instance 1 ... 64
You can define up to 2 MSTP
instances.
Default:
The VLANs 1 – 4094 are as-
signed to instance "0"
vlan
Keyword for a VLAN connection
-
vlan-range
Range of VLANs assigned to an in-
stance
enter the range limts with a hy-
phen or blank

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English