Siemens SCALANCE W760 - Spanning-Tree Mst Max-Hops

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
236 Configuration Manual, 11/2014, C79000-G8976-C351-03
Result
The "root bridge" function is disabled.
Further notes
You enable the root bridge function with the spanning-tree mst instance-id root command.
You display this setting and other information with the commands that start with
show
spanning tree ...
.
6.3.3.12
spanning-tree mst max-hops
Description
With this command, you configure the maximum number of nodes (hops) that a path can run
through in an MST.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree mst max-hops <value(6-40)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
value
Maximum number of hops that a path
can run through in an MST
6 ... 40
Default: 20
Result
The setting for the maximum number of hops is configured.
Further notes
You can reset the setting for the maximum number of nodes to the default with the no
spanning-tree mst max-hops
command.
You display this setting and other information with the
show spanning tree mst
configuration
command.