Siemens SCALANCE W760 Configuration Manual

Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
211
Syntax
Call the command without parameters:
no switchport ingress-filter
Result
The ingress filter is deactivated.
Further notes
You enable the filter with the switchport ingress-filter command.
You can display the status of the ingress filter and other settings with the
show vlan port
config
command.
6.2.3.6
switchport priority default
Description
With this command, you configure the priority default for the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport priority default <0-7>
The parameter has the following meaning:
Parameter
Description
Range of values / note
-
Value for the priority default 0 ... 7
Default: 0
Result
The setting for the default priority of the interface is configured.

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English