Siemens SCALANCE W760 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
250 Configuration Manual, 11/2014, C79000-G8976-C351-03
Result
The selected property is configured.
Further notes
You can reset the setting to the default with the no spanning-tree mst (properties) command.
You display these settings and other information with the commands that start with
show
spanning tree ...
.
6.3.4.9
no spanning-tree mst
Description
With this command, you reset the various properties of the Multiple Spanning Tree function
to the default value.
The default values are as follows:
Parameter
Default value
cost
• 200000 for physical interfaces
• 199999 for port channels
port-priority
128
disable
The Multiple Spanning Tree function is enabled on the interface
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no spanning-tree mst<instance-id(1-64)>{cost|port-priority|disable}
The parameters have the following meaning:
Parameter
Description
Range of values / note
instance-id
Number of the addressed instance
1 ... 64
cost
Keyword for the costs of the port for
calculating the lowest-cost path.
-
port-priority
Keyword for the priority of the interface
-
disable
Enables the interface for multiple
spanning tree.
-

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English