Siemens SCALANCE W760 Configuration Manual

Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
273
Syntax
Call up the command with the following parameters:
ip domain used server {public-only | manual-only | all}
The parameters have the following meaning:
Parameter
Description
Range of values
public-only
The device uses only the DNS servers
assigned by DHCP.
-
manual-only
The device uses only the manually con-
figured DNS servers. A maximum of
three DNS servers can be configured.
-
all
The device uses all available DNS serv-
ers.
-
Result
The device uses the DNS servers specified in the configuration.
7.1.3
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
7.1.3.1
ip address
Description
With this command, you assign an IP address to a VLAN interface.
Requirement
● Interface is a router port
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English