EasyManuals Logo

Siemens SCALANCE W760 Configuration Manual

Siemens SCALANCE W760
432 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
Functions specific to SCALANCE
4.3 iPCF
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
91
Result
The recording is configured and will be started. The measured values are output in the CLI
and logged in files. If these files already exist, they will be overwritten. If the set total number
of measured values is reached, the recording stops automatically.
Use the
wlan signal-recorder <wlan 0/X> stop command to stop the recording early.
During the recording, it is possible that working in the CLI becomes slower.
Further notes
You stop the recording early with the wlan signal-recorder <wlan 0/X> stop command.
You display the status of the signal recorder and the recording with the
show wlan signal-
recorder <wlan 0/X>
command.
4.3
iPCF
This section describes the commands relevant for working with the iPCF function (industrial
Point Coordination Function).
Note
The commands are only available with the following device:
•
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
4.3.1
show wlan ipcf
Note
The command is only available with the following device:
•
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
This command shows the settings of iPCF.

Table of Contents

Other manuals for Siemens SCALANCE W760

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE W760 and is the answer not in the manual?

Siemens SCALANCE W760 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE W760
CategoryWireless Access Point
LanguageEnglish

Related product manuals