Siemens SCALANCE W760 Configuration Manual

Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
281
The parameters have the following meaning:
Parameter
Description
Range of values
mac
The client registers with its MAC address
-
client-id
The client registers with the assigned ID
-
client-id
Name of the assigned ID
max. 32 characters
sysname
The client registers with the assigned system
name
-
Result
The registration mode of the DHCP client is configured.
7.3
DHCP server
This section describes commands relevant for configuring the DHCP server.
Requirement
The connected devices are configured so that they obtain the IPv4 address from a DHCP
server.
7.3.1
show ip dhcp-server pools
Note
The command is only available with the following device:
•
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
The command shows the DHCP server configuration of a specific IPv4 address band or all
IPv4 address bands and the corresponding DHCP options.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English