SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
117
This section describes commands for configuring and managing wireless LANs (WLANs).
Some commands are available only in the "access point" or in the "client" mode. In these
cases, the titles have the term access point or client added to them.
wlan mode
● wlan mode (access point): The function can only be used with access points.
● wlan mode (client): The function can only be used with clients.
This section describes commands with which you display various settings.
show wlan advanced
Description
This command shows information about the send characteristics of the device, for example
the beacon rate, fragmentation.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show wlan advanced <wlan 0/X>
The parameter has the following meaning:
Values or range of values
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
To Next Page
Loading...
Need help?
General
