Functions specific to SCALANCE
4.4 iPCF-MC
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
94 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call the command without parameters:
no wlan ipcf
The iPCF mode is disabled.
You enable the iPCF mode with the wlan ipcf command.
You display the setting with the
show wlan ipcf command.
This section describes the commands relevant for working with the iPCF-MC function
(industrial Point Coordination Function - Management Channel).
Note
The commands are only available with
the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AA0
(US version))
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
This command shows the settings of iPCF-MC.
To Next Page
Loading...
Need help?
General
