Siemens SCALANCE W760 - Wlan Ht Channel Width (Access Point)

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
176 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call up the command with the following parameters:
wlan guard interval { GI400 | GI800 }
The parameters have the following meaning:
Parameters
Description
GI400
The send pause is 400 ns (default)
GI800
The send pause is 800 ns
Result
The function is enabled and the send pause set.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
6.1.5.40
wlan ht channel width (access point)
Description
With this command, you specify the channel bandwidth. With IEEE 802.11n, data can be
transferred via two directly neighboring channels (channel bonding). The two 20 MHz
channels are put together to form one channel with 40 MHz channel bandwidth
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#