Siemens SCALANCE W760 - Ports

Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
216 Configuration Manual, 11/2014, C79000-G8976-C351-03
6.2.4.3
ports
Description
With this command, you generate a static VLAN entry that specifies the use of the ports.
Here, you configure the following types of ports:
● Member ports (tagged ports)
These ports are permanently added to the list of outgoing connections
● Untagged ports
These ports transfer data packets without a VLAN marking
● Forbidden ports
These ports are not used for communication in a VLAN
The tagged and untagged ports specified with this command are used for outgoing data
traffic.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ports
(
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
)
[
untagged<interface-type> <0/a-b,0/c,...>
(
[<interface-type><0/a-b,0/c,...>] [all]
)
]
[
forbidden<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>]
]
[name<vlan-name>]