Siemens SCALANCE W760 - No Wlan any Ssid (Client)

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
153
Result
The function is enabled.
Further notes
You display the setting with the show wlan client <wlan 0/X> command.
You disable the function with the
no wlan any ssid command.
See also
no wlan any ssid (client) (Page 153)
vap broadcast ssid (access point) (Page 188)
6.1.5.15
no wlan any ssid (client)
Description
With this command, you disable the "Any ssid" function. The client attempts to connect to the
access point from the SSID list that provides the best transmission quality and on which the
"Broadcast SSID" option is disabled.
Note
This command is only available in the client mode.
Requirement
● An active SSID is available.
You are in the Interface configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan any ssid
Result
The function is disabled.