Layer 3 functions
9.1 NAT
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
350 Configuration Manual, 11/2014, C79000-G8976-C351-03
nat (client) (Page 351)
nat local ip address (client) (Page 354)
nat interface (client) (Page 355)
nat timeout (client) (Page 356)
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you change to the NAT Configuration mode.
Note
This command is only available in the client mode
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
nat
To Next Page
Loading...
Need help?
General
