SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
259
This part contains the sections that describe the commands for working with the various
network protocols.
This section describes commands of the Internet Protocol (IP) version 4.
This section describes commands with which you display various settings.
show dcp forwarding
Description
This command shows an overview of the DCP forwarding behavior on one or all interfaces.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show dcp forwarding [port<interface-type><interface-id>]
The parameters have the following meaning:
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
To Next Page
Loading...
Need help?
General
