Configuration
3.5 SINEMA
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
80 Configuration Manual, 11/2014, C79000-G8976-C351-03
You enable the function with the auto-save command.
You can display the status of this function and other information with the
show device
information
command.
You save changes to the configuration in the Trial mode with the
write startupconfig
command.
This command shows whether the SINEMA configuration interface is enabled or disabled.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show sinema
The setting of the SINEMA configuration interface is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General
