Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
377
The encryption method is configured.
You display the settings with the show wlan security command.
wlan security default-key (client)
Description
With this command, you specify which WEP key from the key table is used for encryption.
Note
This command is only available in the client mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan security default-key <index(1-4)>
The parameter has the following meaning:
Values or range of values
Index of the key table 1...4
The WEP key is specified.
You display the settings with the show wlan security <wlan 0/X> command.
To Next Page
Loading...
Need help?
General
