Network protocols
7.5 SMTP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
332 Configuration Manual, 11/2014, C79000-G8976-C351-03
With this command, you configure an entry for an SMTP server.
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
smtp-server {ipv4 <ucast_addr> | fqdn-name <FQDN(100)>} <receiver mail-address>
The parameters have the following meaning:
Note on the range if values
Keyword for an IP address
Value for an IPv4 unicast address Enter a valid IPv4 unicast ad-
Keyword for a domain name
Domain name (Fully Qualified Domain
Maximum of 100 characters
Name of the recipient max. 100 characters
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 23)".
An entry for the SMTP server is configured.
You delete an SMTP server entry with the no smtp-server command.
To Next Page
Loading...
Need help?
General
