Siemens SCALANCE W760 Configuration Manual

Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
421
Syntax
Call up the command with the following parameters:
link {up|down}
The parameters have the following meaning:
Parameters
Description
Range of values
up
Only the establishment of a connection is signaled
-
down
Only a break on a connection is signaled
-
Result
The settings for monitoring the physical network connections have been configured.
Further notes
You can display the current setting with the show events faults config command.
You disable the function with the
no link command.
11.1.14.9
no link
Description
With this command, you disable the monitoring of the physical network connections for cable
breaks or for pulling of the connector.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no link {up|down}
The parameters have the following meaning:
Parameters
Description
Range of values
up
The message when establishing a connection is
disabled
-
down
The message when a connection is down is disa-
bled
-

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English