Siemens SCALANCE W760 - No Ip Dhcp-Server Pool

Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
288 Configuration Manual, 11/2014, C79000-G8976-C351-03
Result
The ID of the addressed IPv4 address band is configured.
You are now in the DHCPPOOL Configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Further notes
You exit the DHCPPOOL configuration mode with the exit command.
You delete the entry with the
no ip dhcp-server pool command.
7.3.3.6
no ip dhcp-server pool
Note
The command is only available with the following device:
•
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
With this command, you delete the required IPv4 address band.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip dhcp-server pool <pool-id (1-5)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
pool-id
ID of the addressed IPv4 address band 1 ... 5
Only ID = 1 is supported.