Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
283
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
Note
The command is only av
ailable with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
With this command, you enable the DHCP server on the device.
Note
To avoid conflicts with IPv4
addresses, only one device may be configured as a DHCP
● NAT is enabled
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
ip dhcp-server
The DHCP server is enabled.
To Next Page
Loading...
Need help?
General
