Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
294 Configuration Manual, 11/2014, C79000-G8976-C351-03
You display the setting with the show ip dhcp-server-pools command.
You disable the IPv4 address band with the
no pool-enable command.
You delete the DHCP option with the
no option command.
available when the following requirements are met:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
The IPv4 address band is not enabled.
With this command you configure the DHCP option 67 and the name of the boot file as
DHCP parameter. The DHCP option 67 is created automatically when the IPv4 address
band is created.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call up the command with the following parameters:
option <option-code> value-string <dhcp-param>
The parameters have the following meaning:
Name of the boot file -
The DHCP option 67 is configured.
To Next Page
Loading...
Need help?
General
