Layer 3 functions
9.1 NAT
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
356 Configuration Manual, 11/2014, C79000-G8976-C351-03
no nat interface (client)
Description
With this command, you disable NAT.
Note
This command is only available in the client mode
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Call the command without parameters:
no nat interface
NAT is disabled.
You enable NAT with the nat interface command.
show nat (client) (Page 349)
nat timeout (client)
Description
With this command, you configure the time period for the TCP / UDP connection. If no data
exchange takes place, the TCP / UDP connection is deleted from the translation table when
this time has elapsed.
Note
This command is only available in the client mode
To Next Page
Loading...
Need help?
General
