Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
52 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call up the command with the following parameters:
no interface{vlan<vlan-id(1-4094)>}
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
The logical interface is deleted.
You configure an interface with the interface command.
You display the status and the configuration of the interfaces with the
show interfaces
command.
cli-console-timeout
Description
With this command, you enable the automatic logout and you configure the timeout setting
for the CLI.
Note
No automatic logout from the CLI
If the connection is not terminated after the set time, check the setting of the "keepalive"
function on the Telnet client. If the set interval is shorter than the configured time, the lower
value applies. You
have set, for example, 300 seconds for the automatic logout and the
"keepalive" function is set to 120 seconds. In this case, a packet is sent every 120 seconds
that keeps the connection up.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General
