Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
126 Configuration Manual, 11/2014, C79000-G8976-C351-03
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show wlan data rates <wlan 0/X>
The parameter has the following meaning:
Values or range of values
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
The configured data transmission speeds for the corresponding WLAN interface are
displayed in the form of a table. The display of the tables depends on the selected frequency
band and the transmission standard.
show wlan device
Description
This command shows the WLAN basic configuration for the device, for example the mode
(access point or client).
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show wlan device
To Next Page
Loading...
Need help?
General
