Siemens SCALANCE W760 Configuration Manual

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
320 Configuration Manual, 11/2014, C79000-G8976-C351-03
7.4.2.14
snmp targetaddr
Description
With this command, you configure the SNMP target address.
Requirement
● The SNMP target parameters are configured.
You are in the Global Configuration mode.
The command prompt is:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp targetaddr <TargetAddressName> param <ParamName>{ipv4 <ip address> | fqdn-name
<FQDN(100)>}
[timeout <Seconds(1-1500)][retries <RetryCount(1-3)]
[taglist <TagIdentifier|none>][{volatile|nonvolatile}]
[port <integer(1-65535)>]
Parameter
Description
Range of values
TargetAddressName
Name of the target address
max. 32 characters
param
Keyword for the parameter name -
ParamName
Name of the parameter
max. 32 characters
ipv4
Keyword for an IP address -
ip address
Value for an IPv4 unicast address
Enter a valid IPv4 unicast address.
fqdn-name
Keyword for a domain name
-
FQDN(100)
Domain name (Fully Qualified Do-
main Name)
Maximum of 100 characters
timeout
Keyword for the time the SNMP
agent waits for a response before it
repeats the inform request message
-
Seconds
Time in seconds
1 ... 1500
retries
Keyword for the maximum number of
attempts to obtain a response to an
inform request message
-
RetryCount
Number of attempts
1 ... 3
taglist
Keyword for
•
TagIdentifier
•
none

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English