Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
214 Configuration Manual, 11/2014, C79000-G8976-C351-03
The setting is reset to the default value.
You configure the setting with the switchport pvid command.
You configure the VLAN ID with the
switchport access vlan command.
You can display the status of this function and other information with the
show vlan port
config
command.
Commands in the VLAN configuration mode
This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
vlan $$$ command to change to this mode.
When doing this, you need to replace the
$$$ placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you assign a name to the VLAN.
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
To Next Page
Loading...
Need help?
General
