EasyManuals Logo

Siemens SCALANCE W760 Configuration Manual

Siemens SCALANCE W760
432 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
Configuration
3.3 Reset and Defaults
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
74 Configuration Manual, 11/2014, C79000-G8976-C351-03
3.3
Reset and Defaults
This section describes commands for restarting the device and for restoring the original
configuration.
3.3.1
restart
Description
With this command, you restart the device.
Select one of the following configuration settings:
Device restart with the current configuration
Device restart with the factory configuration settings with the exception of the following
parameters:
IP addresses
Subnet mask
IP address of the default gateway
DHCP client ID
DHCP
System name
System location
System contact
User names and passwords
Mode of the device
Device restart with the factory configuration settings.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#

Table of Contents

Other manuals for Siemens SCALANCE W760

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE W760 and is the answer not in the manual?

Siemens SCALANCE W760 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE W760
CategoryWireless Access Point
LanguageEnglish

Related product manuals